ڤيتوتوب اي سي 198

The surface should be sound, clean, free from loose material, grease, laitance, dirt curing compound, etc. 

Laitance and weak surface layer shall be removed using mechanical methods such as grinding or blasting to provide a sound, well-profiled surface. Repair all necessary repairs before application by using epoxy mortar from the Vetorep ER range. 

New concrete floors shall be at least 28 days old with a moisture content of less than 5% (shall earlier application be required testing of substrate for moisture conditions shall be made). 

Steel substrates should be grit blasted to surface quality SA2½ (BS 4232:Second Quality), then apply Vetoprime EP390, wait till it dries, then continue the application of Vetotop EC198. 

Generally, no primer is required to use Vetotop EC198 on cementitious substrates; however, where highly absorbent cementitious surfaces exist, Vetoprime AP443 can be used. For metal substrate, it is mandatory to use primer recommended Vetoprime EP390 before application.

Thoroughly stir the individual components of Vetotop EC198 before mixing. Pout the entire content of the hardener container into the base container and thoroughly mix the material for at least 3 minutes. The use of a heavy-duty slow speed drill fitted with a mixing paddle is desirable. 

Apply the mixed Vetotop EC198 to the prepared surface using a brush or lambs-wool roller. Ensure that the area is completely coated and that the ‘ponding’ of the material does not occur.

The applied coating can receive foot traffic in 24 hours; however, it is recommended to cure for 7 days to achieve a full cure to receive vehicular traffic and chemical resistance properties.

Remove Vetotop EC198 from tools and equipment with water immediately after use. Remove hardened material mechanically.