Submitted by webmaster on 19 May 2024

Vetoproof CM744

Polymer modified water resistant cementitious top coat.

Vetoproof CM744 is a two-component polymer modified protective coating for concrete and masonry, its supplied in ready to mix kits that can be applied by stiff brush or trowel. Vetoproof CM744 is used to re-face and even out variations in concrete and masonry surfaces. It provides a seamless, slightly flexible waterproof coating suitable for water tanks, reservoirs, and roofs. The product provides a tough, durable wear-resistant coating that can withstand light pedestrian traffic, has excellent weather resistance for exterior applications, and provides a decorative function. *Discoloration may occur due to the elements, but the function remains intact*.

Uses

  • As a textured protective cementitious finish for boundary walls, blocks, concrete...etc.
  • Waterproofing under tiles in wet areas.
  • To protect atmospherically exposed reinforced concrete structures from attack by acid gases, chloride ions, oxygen and water

Advantages

  • Excellent barrier to carbon dioxide, chloride ions, and water.
  • Allows water vapor to escape from the structure.
  • Waterproof.
  • Good resistance to weathering, durable in all climatic conditions, including UV attack.
  • Cost-effective.
  • Non-toxic - ideal for potable water tanks.
  • Covers honeycombed and pitted poured concrete effectively

Usage Instructions

All surfaces should be dry and free from contamination, such as oil, grease, loose particles, decayed matter, moss algal growth, laitance, and all traces of mold release oils and curing compounds. This is best achieved by lightly gritblasting the surface. Where moss, algae, or similar growths have occurred, treatment with a proprietary biocide should be carried out after the grit-blasting process. Spalled and deeply disintegrated concrete should be removed to sound concrete and repaired with a Saveto repair system. For further advice, consult the local Saveto office. It is essential that all surfaces that receive Vetoproof CM744 be presoaked with clean water before applying Vetoproof CM744.

Pour Vetoproof CM744 liquid concentrate from the plastic container into a suitably sized mixing container. Commence mixing with a propeller agitator attached to a slow speed drill (300-500 rpm). Add the powder component gradually to the liquid to avoid lump formation and mix for 2 to 4 minutes. Use Vetoproof CM744 immediately after mixing. Do not mix more material than can be used within the pot life. Keep mixing Vetoproof CM744 during the application.

For best results, surfaces should be damp. To obtain the protective properties of Vetoproof CM744, observe the correct rates of the application. Use a short, stiff brush, preferably 120-200mm width, and apply in one or two coats as required. Trowel applications should use the correct mixing ratio to obtain satisfactory consistency.

The application of Vetoproof CM744 should not commence if the temperature of the substrate is below 5ºC. Application of Vetoproof CM744 on hot substrates, i.e., over 35ºC, is not recommended. It is recommended that for general resurfacing, each coat should be 1mm thick. Areas subjected to light foot traffic should receive at least 2mm thickness of Vetoproof CM744, and an additional 2mm should be applied if conditions are moderate to heavy pedestrian traffic. If in doubt about the condition of the substrate, consult Saveto technical department for any additional information.

Clean tools with water promptly before material hardens. Hardened material can be mechanically removed.

DOWNLOADS

EXPLORE MORE PRODUCTS

Vetonit Cool Top

Hybrid Acrylic Polyurethane Roof Waterproofing.

Waterproofing

Vetoproof AM763

Acrylic Waterproofing.

Waterproofing

Vetoproof AM764

Pure Acrylic Waterproofing.

Waterproofing