Glass fiber reinforcement meshes designed for use with coatings, sealants and tile setting products.
Vetoflex GFR is a range of ready to use thin glass fiber meshes that are used with floor and wall coatings, sealants and tile setting products as a reinforecment against crack formation and provide a high tensile strength composite coatings. The range includes various weights and opening sizes depending on project and engineers requirements.
Vetofiber GFR10 is supplied in 50 x 110 m rolls
Vetofiber GFR11 is supplied in 25 x 110 m rolls
Vetofiber GFR12 is supplied in 75 x 110 m rolls
Vetofiber GFR has a shelf life of 24 months provided it is stored clear of ground in a dry shaded place below 35ºC.
Embed the fiber glass mesh into the upper third of coatings.
Always allow for a 10 cm overlap between rolls.
Use alluminium rollers to compact the mesh into place.
Consult with individual product technical datasheet requirements for Vetofiber GFR usage.
All suitable substrates must be smooth, structurally sound and free of any substance that could prevent adhesion.
Do not use chemical means (acid etching or stripping) to prepare approved substrates. Use mechanical methods only.
To remove any bond-inhibiting materials, concrete substrates should be mechanically cleaned and prepared by diamond-cup grinding or other engineer- approved methods to obtain the International Concrete Repair Institute (ICRI) concrete surface pro le (CSP) of #2. When concrete requires more mechanical preparation, the profile will typically increase. In such cases, the surface can be made smooth by applying coats of a Saveto Vetorep range of products.
Consult Vetoproof range Technical Data Sheets of individual waterproofing products for other important surface preparation instructions. For other details contact Saveto Technical Services Department.
Refer to Material Safety Data Sheet for further information.
Saveto endeavors to ensure that any advice, recommendations, information it may give, is accurate and correct. It cannot accept any liability either directly or indirectly arising from the use of its products, because it has no direct or continuous control over where or how its products are applied, whether or not in accordance with any advice, specification, recommendation or information given by us. Saveto has the right to change any of the specifications mentioned in the Technical data sheets upon its discretion without prior notification.
Hard copies of TDSs are printed once or twice a year, while our technical data sheets are continuously being updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.
Multi-purpose bonding agent & admixture
Multipurpose low viscosity bonding agent & admixture
High Quality Monofilament Polypropylene Fibers
Polymeric soil stabilizer
Polymeric bonding agent, waterproof mix enhancer & primer
Waterproof dynamic load bearing epoxy grout