Glass fiber reinforcement meshes designed for use with external thermal insulation coating systems.
Vetotherm Mesh is a range of ready to use thin glass fiber meshes that are used with wall coatings and claddings including external thermal inslation systems ETICS / EIFS as a reinforecment and impact resistance against crack formation and provide a high tensile strength composite system. The range includes various weights and opening sizes depending on project and engineers requirements.
Vetotherm Mesh 50m2 : (50m x 1m) rolls, supplied in 30 rolls/ carton
Vetotherm Mesh 25m2 : (25m x 1m) rolls, supplied in 30 rolls/ carton
Vetotherm Mesh has a shelf life of 24 months provided it is stored clear of ground in a dry shaded place at -100C to +500C.
Product Application
Embed Vetotherm mesh into the upper third of the body or top coat.
Always allow for a 10 cm overlap between rolls.
apply Vetotherm Mesh at corners and window reveals where necessary. A diagonal reinforcement must be made on building openings with angles or Vetotherm Mesh with minimum dimensions 20 x 40 cm.
Use alluminium rollers to compact the mesh into place. The mesh must be handled with care to prevent damage during application.
Consult with individual product technical datasheet requirements for Vetotherm Mesh usage.
All suitable substrates must be smooth, structurally sound and free of any substance that could prevent adhesion.
Do not use chemical means (acid etching or stripping) to prepare approved substrates. Use mechanical methods only.
To remove any bond-inhibiting materials, concrete substrates should be mechanically cleaned and prepared by diamond-cup grinding or other engineer- approved methods to obtain the International Concrete Repair Institute (ICRI) concrete surface pro le (CSP) of #2. When concrete requires more mechanical preparation, the profile will typically increase. In such cases, the surface can be made smooth by applying coats of a Saveto Vetorep range of products.
Consult Vetoproof range Technical Data Sheets of individual waterproofing products for other important surface preparation instructions. For other details contact Saveto Technical Services Department.
Refer to Material Safety Data Sheet for further information.
Saveto endeavors to ensure that any advice, recommendations, information it may give is accurate and correct. It cannot accept any liability either directly or indirectly arising from the use of its products because it has no direct or continuous control over where or how its products are applied, whether or not following any advice, specification, recommendation, or information given by us. Saveto has the right to change any of the technical datasheets' specifications upon its discretion without prior notification.
Hard copies of TDSs are printed once or twice a year. Our technical data sheets are continuously updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.
Closed cell polyethylene backing rod
Saveto plaster accessories - plaster architrave beads
Saveto plaster accessories - angle beads
Saveto block reinforcement access-ories ladder type
Saveto plaster accessories - plaster control joint
Acrylic polymer modified decorative finish coat applied at thicknesses from 3 to 20mm