Submitted by webmaster on 16 May 2024

Ready-Mix Bond

Multi-purpose bonding agent & admixture.

Ready Mix Bond is a single component acrylic-based bonding agent for cementitious materials. It is water-based, specially formulated to enhance bonding properties and improve the mechanical strengths of plaster mixes when incorporated with mixing water. Ready Mix Bond reduces shrinkage cracks during the early stages of cement hardening by minimizing surface water loss in freshly applied mixes. Ready Mix Bond is ideal for use with a variety of sand/cement-based mixes. Ready Mix Bond can be diluted on site with potable water for desired applications.

Uses

  • Use neat Ready-Mix Bond without dilution. Apply Plastering Bond using a brush or spray directly onto the substrate. If using a hand pump, spray at a rate of 4-6 m2/liter.
  • While bonding agent is wet to tacky, follow immediately by applying plaster, screed, render, mortars, etc.
  • Note: Vetonit Ready-Mix Bond should remain tacky when applying topcoat finishes.

Advantages

  • Multipurpose usage.
  • It can be used as a bonding agent & admixture.
  • Enhances bonding of plaster, sand/cement screed, renders, etc.
  • Improves hydration & curing when added to cementbased mixes.
  • Improves compression strength & abrasion.
  • It adheres well to various construction materials, including concrete, stone, etc.
  • Ensure brighter & long-lasting color to architectural finishes.
  • Reduces shrinkage & cracks.

Usage Instructions

Clean all surfaces and remove any dust, unsound material, plaster, oil, paint, grease, corrosion deposits, or algae. Roughen the surfaces, remove any laitance and expose aggregate by light scabbling or grit-blasting.

Ready Mix Bond tends to soft settlement on storage, and therefore it is recommended to mix the material in the same container before use. 

Follow the dilution ratio required for each type of premixed mortar.

Add 3 parts of Ready Mix Bond with 1 part of water. Mix thoroughly to obtain uniform consistency liquid. Add the diluted Ready Mix Bond to pre-blended sand/ cement plaster, mortar, or other dry mixes. Mix for 3-4 minutes using a mechanical mixer at low speed. 

Let the mixture stand for 10 min and mix again briefly to achieve a homogeneous lump-free mixture.

As As a bonding agent, Ready Mix Bond is used without dilution. Apply Ready Mix Bond using a brush or spray directly onto the substrate. If using a hand pump, spray at a rate of 8-10 m2/liter. 

Immediately, while the bonding agent is still wet, follow by applying plaster, render, mortars or joint tapes, etc.

Note: Ready Mix Bond should remain tacky when applying topcoat finishes

Clean tools with water before it hardens. After the hardening, remove its residuals mechanically only.

DOWNLOADS

Please login to download

EXPLORE MORE PRODUCTS

Plastering Bond

Bonding agent and admixture for render and plaster.

Bonding Agents & Primers

Vetonit Bond Pure

Multipurpose bonding agent & admixture.

Bonding Agents & Primers

Vetonit Bond 2

Multipurpose, low viscosity bonding agent & admixture.

Bonding Agents & Primers