Vetotop CS360

The surface should be sound, clean, free from loose material, grease, laitance, dirt curing compound, etc.

Vetotop CS360 can be laid as a bonded screed by applying Vetobond AB432 slurry to the prepared concrete substrate as a bonding and priming layer.

Alternatively, Vetobond AB432 can be used alone diluted or pure depending on the substrate conditions.

if the old substrates , dilute AB432 with water 1:1 and one layer is enough.

for new absorbent substrates, first layer 1 volume AB432 : 3 Volumes water, then after full dry another layer 1:1 , the application of the product after full dry of the bonding agent AB432.

To prepare the slurry primer, mix 1 volume of Vetobond AB432 to 1 volume of clean water with 3 volumes of fresh cement and mix until achieving a smooth consistency. Scrub the mixed slurry into the concrete surface. While the slurry is wet, apply Vetotop CS360 to ensure good adhesion with the substrate.

For the mixture’s preparation, pour into a container 5 - 6 liter of water for each 50Kg bag of Vetotop CS360.

Add the powder to the water while mixing and mix with a low-speed electric drill fitted with a suitable paddle until achieving a uniform, lump-free consistency mix. Do not add further water to the mix. Do not add water to the mix once it starts to set.

Pour the mixed material onto the surface and spread it to the desired thickness using a steel trowel or suitable tools. Cover the Vetotop CS360 with a plastic sheet to avoid fast drying .

Curing is not required, only keep the plastic sheet on top of the material as maximum as you can.

Clean tools with water promptly before material hardens. Hardened material can be mechanically removed.