High quality elastic one component moisture cure silicone sealant
Vetoflex SS783 is a high quality moisture cure, single component silicone sealant. The product is used as a general purpose sealant for most construction finishes works including aluminum frames perimeter sealing, sanitary fittings sealing. The product exhibits typical acedic smell and classified as a general purpose multi function sealant.
Vetoflex SS783 is supplied in 280 mL cartridges
|Joint Width(mm)||Joint Depth (mm||Length Filled / Cartridge (m)|
Original sealed container of Vetoflex SS783 has a shelf life of 12 months provided it is stored clear of ground in a dry shaded place below 25ºC.
Vetoflex SS783 is a general purpose sealant and should not be used as a sealant for expansion or contraction joints in concrete and has typical acedic smell.
Cut and remove the tip of the cartridge and place it in an air operated or manual gun. Fit the nozzle and cut at 45 degrees to a suitable size for sealing the joint. Extrude the sealant firmly in to the joint. Tool flush within 5 minutes of application to ensure good contact between the sealant and the substrate.
Vetoflex SS783 should be removed from tools, equipment and mixers with Vetonit Solvent XX400 immediately after use. Hardened material can only be removed mechanically.
Clean all joint surfaces and remove any dust, unsound material, plaster, oil, paint, grease, corrosion deposits or algae. Roughen the surfaces, remove any laitence and expose aggregate by light scabbling or grit-blasting.
Oil and grease deposits should be removed by steam cleaning, detergent scrubbing or the use of a proprietary degreaser.
Any joint filler must be checked to ensure it is tightly packed and no gaps or voids exist at the base of the sealing slot before positioning a bond breaker.
The use of a bond breaker is not required in expansion joints containing cellular polyethylene joint filler, backing rod (Vetoflex PBR). For contraction joints a bond breaker tape or back-up strip must be used.
Where a particularly neat finish is required, mask the face edges of the joint before sealing and remove immediately after tooling is completed.
Avoid contact with eyes and skin. The use of protective gloves is recommended. Do not swallow.
For information and advice on the safe handling, storage and disposal of chemical products, users shall refer to the most recent Material Safety Data Sheet containing physical, ecological, toxicological and other safety-related data.
Saveto endeavors to ensure that any advice, recommendations, information it may give, is accurate and correct. It cannot accept any liability either directly or indirectly arising from the use of its products, because it has no direct or continuous control over where or how its products are applied, whether or not in accordance with any advice, specification, recommendation or information given by us. Saveto has the right to change any of the specifications mentioned in the Technical data sheets upon its discretion without prior notification.
Hard copies of TDSs are printed once or twice a year, while our technical data sheets are continuously being updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.
Closed cell polyethylene backing rod
Multi-component polyurethane joint sealant
(Formerly known as Saveto PU2)
Two-component polysulphide trafficable joint sealant
(Formerly known as Saveto PS2)
High performance, elastomeric, single component polyurethane sealant
(Formerly known as Saveto PU1)
Two-component trafficable, jet fuel resistant heavy duty pitch-polysulphide sealant.
Epoxy Polysulphide Elastomeric Coating System