Apply Porcelain Plus Green on the substrate by using a suitable trowel depending on the tile size (preferably a 12 mm notched trowel for a slab), then comb it in one direction, Apply Porcelain Plus Green on the slab’s backside using the flat edge of the trowel (Back buttering), do not comb. Install the slab in its place then tap and press firmly (or use a tile fixing vibrator) to ensure that the tile is sitting on the substrate with the maximum coverage and contact between the tile’s back and the adhesive on the substrate.
Do not apply Porcelain Plus Green on an area that takes more than 15 minutes to be tiled!
A useful practice to check the application efficiency is to remove a slab after application directly and observe the contact surface (adhesive on substrate and slab’s back), this can be done randomly as per the applicator’s point of view and then reinstalled again (this should always be done for the first slab so that the applicator will have an idea on how much adhesive needed for the best contact).
Recommended coverage to be more than 100%. The slab position can be adjusted without losing any adhesion for 15 minutes.
Leave installed tiles undisturbed for at least 24 hours. Porcelain Plus Green must not rise between the tile joints higher than half to two-thirds of the thickness of the porcelain slab tiles. It is recommended to use Vetonit Tile Grout to fill the joint gaps 2 days from tile installation.
Notes:
- Low temperatures and high air humidity will retard the curing and drying process and vice versa.
- The best coverage can be achieved on flat surfaces.
