Tile Fix Universal - AE

The surface should be sound, clean, and free from loose material, oil, grease, laitance, dirt, curing compound, etc. 

Wet all surfaces with clean water before applying adhesive. The surface should appear damp with no water pooling.

For the mortar adhesive preparation, pour 6.0 - 7.0 L. of water into a container then the powder from the 25 Kg bag of Tile Fix Universal and mix using a low-speed electric drill fitted with a suitable paddle until a uniform, lump-free consistency is achieved. For a 50 kg bag, use 12 - 14 L. of water. 

Allow the mixed material to stand for about 10 minutes and remix briefly without adding further water. 

You can blend the adhesive manually for small quantities, however, the correct water-to-powder ratio must be maintained. 

Do not add water to the mixture once the mortar adhesive begins to harden.

Spread the mixed mortar adhesive, and firmly press it onto the surface that will be tiled; work with a notched trowel. Spread the mortar adhesive to an area that can be tiled within 10 minutes. Press the tiles firmly over the mortar adhesive and immediately knock them into the desired position. Adjust the position of the tiles, if required, within the recommended adjustability time of 10 - 15 minutes after installation. 

Allow the installed tiles to remain undisturbed for at least 48 hours. Mortar adhesive must not rise between the tile joints higher than half the thickness of the tiles. It is recommended to use Vetonit Tile Grout to fill the joint gaps after 2 days of tile installation. 

For further information regarding the suitable substrates and tiles on which this product can be safely applied, please contact Saveto’s technical department.

Clean tools and equipment with water immediately after use. Remove the hardened material using mechanical means.