Vetofill CG550 - AE

Remove all tile adhesive excess that is at a level higher than half of the tile thickness. 

All the joints should be free from dust, loose materials & traces of foreign materials, etc. Neutralize the tiles' water absorption by applying clean potable water. 

Do not leave water pooling in the joints.

Add 6.4 - 7.4 Liters of fresh, clean water to a suitably sized mixing vessel. Slowly add the powder component while mixing using a mixer fitted with a Saveto approved paddle until achieving a uniform, lump-free consistency. 

Important Note: Do not mix partial quantities unless an exact proportion based on volume can be achieved using proper tools. 

Use the mixed material within 1 hours. 

Do not add water to the mixture once the mortar grout starts to harden.

Apply Vetofill CG550 using either a rubber blade, a grouting trowel, a rubber spatula, or a sponge. Spread the mixed grout diagonally across the tile joints and firmly press it with a rubbing pad covered with a sponge rubber spatula to ensure filling all the gaps. 

Remove excess grout that remains on tiles using the same tool. 

After the grout initially dries, from 20-30 minutes, depends on the ambient temperature & humidity, clean the tiles and remove all excess material with a wet sponge. After full drying, clean the surface of the tiles with a dry cloth or dispensable cotton towels. 

When washing & drying the tiles, ensure not to rub the tile joints too deep. 

Moist the grout from time to time for the first 2 days after application to ensure achieving good hardened properties. 

For further information regarding the suitable substrates and tiles on which this product can be safely applied, please contact Saveto technical department.

Clean tools and equipment with water immediately after use. Hardened materials will require removal by mechanical means.