ڤيتوست سي آى 545

The substrate should be sound, clean, and free from loose material, grease, laitance, dirt, curing-compounds (or any other substance that might impair bond quality with the substrate). Concrete, hollow blocks, and cement-based substrates must be sufficiently cured and irrigated with water 1 hour before application. Gypsum boards, plasterboards, anhydrite screeds must be sufficiently dry and free from dust.

Add the 7 liter liquid part of Vetoset CA545 and the 20 kg bag to a mixing container. Add the powder to the liquid then mix with a mechanical mixer or a low-speed, heavy-duty electric drill fitted with a suitable paddle for 3 - 4 minutes until a uniform & lump-free consistency is achieved

Apply a thin layer of the adhesive onto the substrate using the flat edge of a trowel. Comb the adhesive with a suitable notched trowel to achieve a bed thickness of 2 - 6 mm. Then place the tiles and press them firmly to ensure proper contact with the adhesive. (It is always better to work in a manageable area that can be tiled within the adhesive’s open time). Leave tiled surfaces for 24 hours before grouting. Note: The adhesive bed’s thickness is directly proportional to the size and thickness of the tile. Contact Saveto’s technical department for more information regarding the suitable substrates and tile types on which this product can be safely applied.

Clean tools and equipment with water immediately after use. Remove hardened material mechanically