ڤيتوتتش ديكور اف بي

All new concrete surfaces must be cured for at least 28 days prior to the application of the primer. 

For previously painted surfaces, remove old paint completely. The substrate should have sufficient strength and be free from unsound areas, pug holes, protrusions, and pops.

Ensure that the surface is clean, dry, and free from dust, oil, grease, salt, mold, and all forms of release agents/curing agents. A light sanding with suitable abrasive material is recommended before application. Any resulting dust or loose particles must be removed before application.

Priming is not required for good quality non-porous concrete. However, if the concrete surface is porous or if there is any doubt about the quality of the concrete surface, use Vetoprime Décor. 

Apply one coat of Vetoprime Décor for both exterior and interior applications and allow it to completely dry before proceeding.

Stir well before use with a flat paddle to achieve a homogeneous consistency. Stir occasionally during use. Additives are not permitted. Close the container when not in use.

Apply and level Vetotouch Décor FB using a roller, brush, or spray gun during the same operation to achieve the minimum obtainable thickness consistent with uniform coverage.

Remove Vetotouch Décor FB from tools, equipment, and mixers with clean water before the initial set. Cured material can only be removed mechanically.