ڤيتوفيل سي جي551

Remove all tile adhesive excess that is at a level higher than half of the tile thickness. All the joints should be free from dust, loose particles and traces of foreign materials, etc. Neutralize the tiles’ water absorption by applying clean potable water. Do not leave water pooling in the joints

Add 6.4 - 7.4 Liters of fresh, clean water to a suitably sized mixing container. Slowly add the powder component while mixing with a mixer fitted with a Saveto-approved paddle until a uniform, lump-free consistency is achieved.

Important Note: Do not mix partial quantities unless the exact proportion (based on volume) can be measured. You should also use the proper tools to achieve the exact ratios.

You can enhance the material’s performance if required. To do this, add 0.5 a liter of Vetobond PB434 to the mixing water, then add the powder.

Use the mixed material within 4 hours. 

Do not add water to the mixture once the mortar grout begins to harden.

Spread the mixed grout diagonally across the tile joints and firmly press it with a rubbing pad covered with a sponge rubber spatula to ensure all the gaps are filled. Remove any excess grout using the same tool.

After the grout initially dries (from 20 - 30 minutes, depending on the ambient temperature and humidity), clean the tiles and remove all excess material with a wet sponge

After fully drying, clean the surface of the tiles with a dry cloth or disposable cotton towels.

Note: When washing and drying the tiles, Do not rub the tile joints too deep

Keep the grout moist often for the first 2 days to achieve the material’s full hardness properties.

For more information regarding the suitable substrates and tiles on which this product can be safely applied, contact Saveto’s technical department.

Clean tools and equipment with water immediately after use. Remove hardened material mechanically