تجاوز إلى المحتوى الرئيسي
Submitted by webmaster on 6 June 2024

ڤيتوتوب سي اس 535

خلطة إسمنتية مسبقة الخلط 10-30 مم

Vetotop CS535 is a single component cementitious floor screed composed of hydraulic binders, silica sand, selected aggregates, special additives, and fibers. It is supplied as a dry powder in pre-weighed bags ready to use on-site; once mixed, it will form a trowelable mortar applied in thicknesses between 10 and 30 mm.

الاستخدامات

  • Leveling of concrete slabs before the application of final floor coverings. 
  • Screeding over hollow-core pre-cast concrete slabs. 
  • Leveling floors and slabs to slope to ensure proper flow to drains.

المزايا

  • Factory-controlled pre-blend ensures consistently high quality. 
  • Suitable for Middle East harsh weather conditions. 
  • Easy application enabling high productivity & superior finishing. 
  • Excellent physical and mechanical properties. 
  • Shrinkage compensated. 
  • Excellent workability. 
  • Fiber-reinforced resisting crack formation.

تعليمات الاستخدام

The surface should be sound, clean, free from loose material, grease, laitance, dirt curing compound, etc.

Vetotop CS535 can be laid as a bonded screed by applying Vetobond PB434 slurry to the prepared concrete substrate as a bonding and priming layer. 

Alternatively, an epoxy bonding agent can be used, such as Vetobond EB430 or Vetobond EB431. 

To prepare the slurry primer, mix 1 volume of Vetobond PB434 to 1 volume of clean water with 3 volumes of fresh cement and mix until achieving a smooth consistency. Scrub the mixed slurry into the concrete surface. While the slurry is wet, apply Vetotop CS535 to ensure good adhesion with the substrate.

For the mixture’s preparation, pour into a container 6.5-8 liters of water for each 50Kg bag of Vetotop CS535. 

Add the powder to the water and mix with a low-speed electric drill fitted with a suitable paddle until achieving a uniform, lump-free consistency mix. Do not add further water to the mix. Do not add water to the mix once it starts to set. 

Add the required aggregate type to the mixed screed slowly while continuing mixing until a uniform consistency is achieved.

Pour the mixed material onto the surface and spread it to the desired thickness using a steel trowel or suitable tools.

Cure the screed as per standard concrete curing practices. Do not subject the screed to vehicular traffic for 28 days till ensuring full cure and the system’s ability to withstand designed traffic loads. 

If a concrete sealer requires enhancing the screed durability

تحميل

استكشف المزيد من المنتجات

ڤيتوتوب يو سي 363

غشاء عزل مائي بولي يوريثان لأرضيات المرور

ڤيتوتوب اي سي 498

طلاء إيبوكسي خالٍ من المذيبات

ڤيتوتوب سي ال 530

طبقة تسوية ذاتية أسمنتية 2-10 مم