ڤيتوفليكس بي اس 782

The components of Vetoflex PS782 are supplied in the correct mixing ratio. Add the entire contents of the hardener component into the base container and mix thoroughly for three minutes using a slow speed drill (300 to 500 rpm) fitted with a suitable mixing paddle. Ensure any settlement is thoroughly dispersed. 

Scrape down the sides of the container to ensure that any unmixed components do not remain. Continue mixing for a further 2 minutes.

Pour the mixed Vetoflex PS782 directly from the mixing container by compressing the sides to form a pouring lip. Pour into the prepared joint to the required level. Should the joint width prohibit direct pouring from the container, pour the mixed material into a Vetoflex Barrel gun and apply it to the joint. After a few minutes, it may be necessary to top up the sealant level if it has flowed into joint irregularities. Finally, use a strip of any masking tape. When using gun grade, follow the same application procedure of using a bulk gun. Fill the bulk gun using a follower plate.

Remove Vetoflex PS782 from tools, equipment, and mixers with Vetonit Solvent XX400 immediately after use. Hardened material can only be removed mechanically.