ڤيتوثيرم اكس بي اس

The substrate should be sound, clean, free from loose material, grease, laitance, dirt, curing compound, etc. Remove crumbled areas, and fill the holes until reaching a stable base. Uneven base - if deviations are greater than 1-2 cm, the facade should be evened.

The initial arrangement of the facade is made by applying a plinth profile with a drip-edge profile. Choose the profile according to the thickness of the thermal insulating material. The profile is leveled utilizing a level and is secured with screw anchors. The profile aims to give a correct horizontal level to the thermal insulation and fix and connect the plinth thermal insulation and the thermal insulation system.

Striking the Thermal Insulation Boards 

Use Saveto Vetotherm Flex as an adhesive applied over the bottom sides of Vetotherm XPS boards. Apply the adhesive as a continuous framework along the edge of the insulation board and in the form of three or four balls in the middle of the board. Stick the boards to the wall while interchanging their adjacent vertical joints like brickwork. Do not leave joints between the boards, and if you get greater gaps, fill them with the insulation material or construction foam, but not with adhesive. 

At external edges, interchange the boards. Around the corners of windows and doors, you must put whole thermal insulation boards, cut on-site along the contour of the hole, so-called “gun.” After the adhesive’s complete drying (min. 48 hours), start grinding rough places at the boards’ connections with a special tool.

Start anchoring Vetotherm XPS boards a minimum of 48 hours after sticking the boards to allow the adhesive to dry completely. The dowels should be mounted according to a diagram depending on the building’s height, the region, and the wind’s strength.

 If Vetotherm XPS has a thickness exceeding 8cm, you need to make a hole of 2cm depth previously with a cutter, then in this hole, drill an opening for the screw anchor. After the mounting of the dowels, fill the hole with a polystyrene cap.

 After completing the anchoring, cover the dowels’ heads with Saveto Vetotherm Flex to flush with the boards’ level.

Apply ready-to-use angle profiles Vetotherm ACP to reinforce external angles. Apply Saveto Vetothem Flex along the edge, place the profile and press it tightly. 

Strengthen the corners around doors and windows by applying adhesive on the base, then place on the adhesive pieces of fiberglass mesh with minimum dimensions of 20х50 cm. Apply more adhesive to cover the mesh completely. 

Before continuing to reinforce the entire surface, wait 24 hours to allow these areas to dry.