ڤيتوتوب سي اس 536

Vetotop CS536 can be laid as a bonded screed by applying Vetobond PB434 slurry to the prepared concrete substrate as a bonding and priming layer. 

Alternatively, an epoxy bonding agent can be used, such as Vetobond EB430 or Vetobond EB431. 

To prepare the slurry primer, mix 1 volume of Vetobond PB434 to 1 volume of clean water with 3 volumes of fresh cement and mix until achieving a smooth consistency. Scrub the mixed slurry into the concrete surface. While the slurry is wet, apply Vetotop CS536 to ensure good adhesion with the substrate.

For the mixture’s preparation, pour into a container 5-6 liters of water for each 50Kg bag of Vetotop CS536. 

Add the powder to the water and mix with a low-speed electric drill fitted with a suitable paddle until achieving a uniform, lump-free consistency mix. Do not add further water to the mix. Do not add water to the mix once it starts to set.

Pour the mixed material onto the surface and spread it to the desired thickness using a steel trowel or suitable tools. Cover the Vetotop CS536 with a plastic sheet to avoid drying.

Cure the screed as per standard concrete curing practices. Do not subject the screed to vehicular traffic for 28 days till ensuring full cure and the system’s ability to withstand designed traffic loads.

 If a concrete sealer requires enhancing the screed durability and resistance to water ingress, apply Vetoseal XW770 at a rate of 8 to 12 m2 per liter. Make sure to apply the sealer uniformly and to cover all screed surfaces.

Clean tools with water promptly before material hardens. Hardened material can be mechanically removed.