Vetonit PCL

Saveto plaster accessories - plaster coil lath 


Plaster Coil Mesh Lath is produced for brick and block work reinforcement.
Its primary usage is to prevent cracking.
Fast Download
Technical Data Sheet
download (*.pdf 1.15Mb)
Technical Information
Product Description

Vetonit PCL is a length of expanded steel mesh with continuity of steel throughout. Vetonit PCL reinforces block work in all types of buildings by adding tensile strength to the inherent compressive strength of the traditional construction method.


  • Easy to apply.
  • No joints, welds, or interweaving to fail under stress.
  • Once mortared into brickwork, the diamond-shaped mesh is anchored immovably to not slip under tension.
  • Allows reinforcement for plaster and asphalt, over wall chases, and for keying smooth surfaces.

ACI: 524R-08 (Building Code Requirements for Masonry Structures).


Packaging & Coverage

Vetonit PCL

Coil width (mm) 

Length (m) 

Vetonit PCL100



Vetonit PCL150



Vetonit PCL200



Application Information
Instructions for use


Vetonit PCL coil lath should be set in the bed joints with its outer edge about 25mm from the face of the blockwork.

A strip 65mm wide should be used in every third course of a 105mm wall as a general rule. Other widths are available for thicker walls.

Combinations of different widths may be used to suit any wall thickness.

Additional Information
Important note

Saveto endeavors to ensure that any advice, recommendations, information it may give, is accurate and correct. It cannot accept any liability either directly or indirectly arising from the use of its products, because it has no direct or continuous control over where or how its products are applied, whether or not in accordance with any advice, specification, recommendation or information given by us. Saveto has the right to change any of the specifications mentioned in the Technical data sheets upon its discretion without prior notification.

Hard copies of TDSs are printed once or twice a year, while our technical data sheets are continuously being updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.

More Products from this section
Vetoflex PBR

Closed-cell polyethylene backing rod

Vetonit PAB100

Saveto plaster accessories  - plaster architrave beads

Vetonit PAB500

Saveto plaster accessories - angle beads

Vetonit PBL

Saveto block reinforcement access-ories ladder type


Vetonit PCJ

Saveto plaster accessories - plaster control joint 


view more
Featured Product
Vetorel XT421

Chemical mold and form-work release agent

Vetorel XT421 is used to treat wooden and metal form-work or molds before the casting of concrete to facilitate form stripping.
Minimizing concrete surface blemishes and pinholes.
Contact us
Choose a country
Saudi Vetonit Co. Ltd. (SAVETO)
P.O. Box 52235 Riyadh 11563, KSA
Toll: (+966 11) 265 3334
Fax: (+966 11) 265 0936
800 124 9009
Fax: (+966 11) 265 0718