Versatile solvent free epoxy based primer
Vetoprime EP691 is a universal primer for the Vetorep and Vetotop product range, it is applied on prepared concrete and cementitious substrates to seal the substrate and enhance bonding topcoats. Vetoprime EP691 is a two-component solvent-free epoxy resin with sealing properties, making it ideal for concrete substrates.
Vetoprime EP691 is supplied in a 15 Liters kit.
Coverage: 7 - 10 m2/Liter.
Stated consumption data are for general guidance. Actual consumption depends on the nature of the substrate, method of application, and wastage.
The original sealed kit of Vetoprime EP691 has a shelf life of 12 months, provided it is stored clear of ground in a dry, shaded place below 35ºC.
Mix Vetoprime EP691 as supplied. Add the entire content of the hardener container to the base container and mix thoroughly for about 2 minutes. Once mixed, apply Vetoprime EP691 immediately in a thin continuous film using stiff brushes or rollers. Avoid over-application and puddles.
Allow Vetoprime EP691 to become tack-free before applying epoxy coating (unless otherwise specified) but well within the open time specified for the given temperature.
The hotter the substrate, the more quickly the primer will become dry.
Clean all tools and equipment immediately after use with Vetonit Solvent XX600.
Vetoprime EP691 must be applied to a sound, clean and dry surface to achieve maximum bond strength between substrate and coating/repair products.
Concrete substrates should be at least 28 days old and the relative humidity of the concrete is 75% or below. Remove laitance deposits on new concrete by light grit blasting, mechanical scrabbling, or grinding.
Where heavy contamination by oil and grease occurs or existing coatings are present, it is essential to remove all contaminations.
Some people are sensitive to epoxy resins, so gloves and a barrier cream shall be used when handling these products. If contact with the resin occurs, it must be removed before it hardens, with resin removing cream follow by washing with soap and water. Do not use solvent.
During use, avoid inhalation of solvent and contact with skin and eyes. Wear suitable protective clothing, gloves, eye protection, and respiratory protective equipment. In case of contact with the eye, rinse immediately with plenty of clean water and seek medical advice. If swallowed, seek medical attention immediately – do not induce vomiting.
Vetoprime EP691 is non-flammable.
Refer to the product Material Safety Data Sheet for further information.
Saveto endeavors to ensure that any advice, recommendations, information it may give is accurate and correct. It cannot accept any liability, either directly or indirectly arising from the use of its products, because it has no direct or continuous control over where or how its products are applied, whether or not following any advice, specification, recommendation, or information given by us. Saveto has the right to change any of the specifications mentioned in the Technical data sheets upon its discretion without prior notification.
Hard copies of TDSs are printed once or twice a year. Our technical data sheets are continuously updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.
Multi-purpose bonding agent & admixture
Multipurpose low viscosity bonding agent & admixture
Polymeric soil stabilizer
Polymeric bonding agent, waterproof mix enhancer & primer
Versatile resin adhesive, cement modifier, bonding agent & sealer
Two-component epoxy zinc-rich and solvent-free primer