Vetoset Parquet

The surface must be sound and clean. Remove any dirt, paint, oil, grease, wax and other contaminants that may act as a bond breaker.

Use the appropriate trowel to apply the adhesive onto the substrate. Evenly distribute the adhesive with a suitable notched trowel. To avoid unnecessary thickness, glide the trowel smoothly through the adhesive at a 45-degree angle. Installation should commence immediately, as no flash time is required. Position the flooring accurately within the adhesive and press down firmly. Rolling is neither necessary nor recommended. Regularly check the boards to ensure proper adhesive transfer from the subfloor to the flooring. Firmly press the covering into the adhesive bed, adjusting until it feels secure. Ensure even and thorough adhesive transfer. Immediately remove any adhesive residue from the floor surface using Vetonit Solvent XX400. Follow the installation guidelines provided by the wood manufacturer. If necessary, place weights on the boards to ensure proper adhesion.

Vetoset Parquet should be removed from tools and equipment with Vetonit Solvent XX400 immediately after use. Hardened material can only be removed mechanically.

• If the substrate is not completely dry or if humidity levels exceed the recommended limits, it is advisable to apply a suitable primer. 
• In the case of potential rising damp, a vapor barrier must be installed prior to the screed application. 
• Installation should not occur if temperatures are below +10°C or above +35°C. 
• Non-absorbent surfaces, such as ceramic and marble, must be sanded or cleaned, followed by treatment with a primer. 
• Ensure that walls and floors are completely dry before laying the flooring. 
• In particularly dry weather conditions, the setting time of the product is extended.