Submitted by webmaster on 5 June 2024

ڤيتوست سي آى 546

غراء أسمنتي للرخام (C2 T).

Vetoset CA546 is a weather-resistant, cementitious adhesive mortar with enhanced characteristics and improved slip resistance. It is composed of hydraulic binders, selected aggregates, and special additives. The product is supplied as a dry powder in pre-measured bags, ready for on-site use (requiring only the addition of clean water to create a workable, cementitious adhesive). Vetoset CA546 is suitable for both internal and external use and is typically applied at thicknesses ranging from 3 to 10 mm.

الاستخدامات

  • Specifically designed for marble and natural stone conglomerates.
  • Suitable for large format tiles.
  • Tiling on normal and smooth concrete surfaces, bricks, and blocks.
  • Suitable for dry and wet conditions.

المزايا

  • Factory controlled pre-blend ensures consistently high quality.
  • Requires only the addition of water on-site at the time of use.
  • Easy tile installation (this enables high productivity).
  • Superior workability.
  • Suitable in dry and humid conditions.
  • Internal and External use.
  • Suitable for horizontal and vertical surfaces.
  • Enhanced mechanical strength.

تعليمات الاستخدام

The surface should be sound, clean, and free from loose material, grease, laitance, dirt, curing compounds, etc.

 Wet all surfaces with clean water before applying Vetoset CA546. The surface should appear damp with no water pooling.

To prepare a mortar adhesive from Vetoset CA546, 5.6 - 6.2 liter (28 - 31%) of water (for each 20 kg bag) into a container. Add the powder to the water then mix with a low-speed (200-300 rpm) electric drill fitted with a suitable paddle until a uniform and lump-free consistency is achieved.

Allow the mixed material to stand for about 10 minutes then remix briefly without adding more water

Using a notched trowel, spread the mixed Vetoset CA546 mortar adhesive and firmly press it onto the surface. (Spread the mortar adhesive to an area that can be tiled within 10 minutes).

Place the tiles onto the fresh adhesive mortar and press them firmly with a slight twist then knock them immediately into the desired position. (You can adjust the position of the tiles within the adjustability time of 10 - 15 minutes after installation).

The mortar adhesive should not rise between the tile joints higher than halfway the thickness of the tiles. Remove any excess adhesive with a damp cloth before it dries.

You can begin grouting the joints between the tiles after 24 hours (for walls) and after 48 hours (for floors). It’s recommended to use Vetonit Tile Grout.

Contact Saveto’s technical department for more information regarding the suitable substrates and tiles on which this product can be safely applied

Clean tools and equipment with water immediately after use. Remove hardened material mechanically

تحميل

استكشف المزيد من المنتجات

غراء بلاط السيراميك

غراء إسمنتى مقاوم للإنزلاق

التبليط

غراء المسابح

غراء تبليط مقاوم للمياه معدَّل بالبوليمير لتبليط المسابح والنوافير وخزانات المياه

التبليط

ترويبة مسابح

ترويبة مقاومة للمياه لملء فواصل بلاط المسابح

التبليط