Submitted by webmaster on 16 May 2024

Vetonit Base WR EG

Weather-resistant, premixed cement coating for external use.

Vetonit Base WR EG is a cement-based coat composed of hydraulic binders, selected aggregates, and special additives. It is supplied as a dry powder in pre-weighed bags ready to use on-site, requiring only the addition of clean water to produce an easily workable mortar. Vetonit Base WR EG is a multi-purpose premium product and a base coat for Vetonit Finish WR EG. Vetonit Base WR EG can be applied in thickness from 1 - 5 mm in layers ( 1 - 2 mm / layer ) in one or two layers depending on the on-site requirement. Vetonit Base WR EG is available in two standard colours: white, grey & Saveto standard colours.

Uses

  • It can be applied externally onto walls & other surfaces in both dry & humid conditions.
  • Suitable for applications on concrete surfaces and precast concrete surfaces.
  • Can be applied on wall surfaces that are plastered with water-resistant plasters & Vetonit Renders.
  • Can be applied on damp concrete interiors.

Advantages

  • Factory-controlled pre-blend ensures consistently high quality.
  • Requires only the addition of water on-site at the time of use.
  • Can be applied manually or using a spray machine.
  • Superior workability.
  • Easy application that enables high productivity.
  • Excellent adhesion on a variety of substrates.
  • Water & weather-resistant.
  • Suitable for humid & dry conditions.
  • Suitable for walls & precast surfaces.
  • Guards surfaces from rain & natural condensation.

Usage Instructions

The surface should be sound, clean, and free from loose material, grease, laitance, dirt-curing compounds, etc. Before applying Vetonit Base WR EG, wet the entire surface with clean potable water, and the surface should look damp at the time of the application.

For manual application, add 7.5 - 8.5 litres of water for each 25 Kg bag of Vetonit Base WR EG to a mixing container. For spray machine application, use 9.5 - 10 litres of water for each 25 kg bag. Add the powder to the water then mix with a mechanical mixer or a low-speed electric drill fitted with a suitable paddle until a uniform, lump-free consistency is achieved.

Allow the mixed material to stand for about 10 minutes then remix briefly without adding more water.

Add 0.5 litres of Vetonit Bond 2 to the mixing water and adjust the water requirement accordingly for each 25 kg bag. Follow the same mixing procedure as described above.

Apply Vetonit Base WR EG to achieve a maximum thickness of 5 mm in all layers (1-2 mm per layer). 

To obtain different finish textures, select different gun nozzle sizes or vary the spraying distance. 

Do not disturb the installed material for at least 48 hours.

Cure Vetonit Base WR EG by spraying the applied material’s surface with water every 12 hours for a minimum of 3 days. During hot & dry conditions, allow curing for a minimum of 5 days. This will help achieve a uniform colour, minimise the risk of surface cracks, and lead to higher mechanical strengths.

Clean all tools with water immediately after finishing. Clean hardened materials mechanically.

DOWNLOADS

EXPLORE MORE PRODUCTS

Putty Fine

PVA based high quality smooth finishing putty.

Surface Treatments & Finishes

Vetogyps Compound

Multipurpose drywall joint compound.

Surface Treatments & Finishes

Vetonit Base WR

Internal Weather Resistant Cement Coating.

Surface Treatments & Finishes