Submitted by webmaster on 16 May 2024

Vetonit Putty WR

Water-resistant, high-quality, & cementitious premixed putty.

Vetonit Putty WR is composed of white cement, fine fillers, bonding chemicals, and high-performance additives. It is supplied as a dry powder in pre-weighed bags ready to use on-site, requiring only the addition of clean water to produce a cohesive mix. Vetonit Putty WR is a premium product and can be applied as a thin underlayment to repair undulations. It provides a fine surface finish that is ideal for subsequent applications of paint or decorative coatings. It is recommended to apply a thin layer of Vetonit Putty WR (1 - 3 mm).

Uses

  • Can be used to level minor surface undulations.
  • Can be applied in wet & dry conditions and onto the walls & ceilings of bathrooms and kitchens.
  • It can be applied on surfaces that are plastered with Saveto products and on gypsum boards.
  • It can be applied on smooth concrete & plastered surfaces and on pre-cast concrete surfaces.

Advantages

  • Factory-controlled pre-blend ensures consistently high quality.
  • Requires only the addition of water on-site at the time of usage.
  • Water-resistant.
  • Excellent adhesion on a variety of substrates.
  • Easy to apply as it requires minimum effort to achieve a superior finish.
  • Ideal for concrete and plastered walls & ceilings.
  • It achieves a smooth finish.
  • Suitable for humid & dry conditions.

Usage Instructions

Make sure the surface is sound, clean, and free from loose material, grease, laitance, dirt-curing compounds, etc. before applying Vetonit Putty WR. Wet the entire surface with clean potable water. The surface should look damp at the time of the application.

For mechanical mixing, add 7.6 - 8.8 litres of water & a 20- kg bag of Vetonit Putty WR to a mixing container. Mix with a mechanical plaster mixer or with a low-speed electric drill fitted with a suitable paddle until a uniform, lump-free consistency is achieved.

Leave the mixed material to stand for 10 mins then briefly remix without adding water. Mix small batch quantities manually until a homogenous mix is achieved. When required, add 1 litre of Vetonit Bond 2 to the mixing water and adjust the water requirement for each 20kg bag of Vetonit Putty WR accordingly. Follow the same mixing procedure as above.

Use the mixed material within 3 hours. Do not add water once the mixed filler mortar starts to harden.

Generally, it is recommended to apply Vetonit Putty WR in single or double coats. Apply Vetonit Putty WR to the substrate by pressing the putty firmly onto it. Use a flat trowel to level the material to a smooth finish. Apply a second coat if necessary once the first coat sets.

After applying Vetonit Putty WR, it is recommended to apply one coat of alkali-resistant primer followed by two coats of acrylic emulsion paint or other suitable coatings.

Vetonit Putty WR is self-curing, and it does not require water treatment. However, when using Vetonit Putty WR as a final finish, it is recommended to apply a single coat of Bond Pure. The bonding agent will act as a surface enhancer and a curing compound & it will naturally disintegrate with time.

Clean all tools with water immediately after finishing. Clean hardened materials mechanically.

DOWNLOADS

EXPLORE MORE PRODUCTS

Vetonit Crack Filler

Premium premixed surface crack filler.

Surface Treatments & Finishes

Vetonit Thick Render

Water resistant thick patch and repair premixed render.

Surface Treatments & Finishes

Vetonit Render

Patch & Repair Premixed Render.

Surface Treatments & Finishes