Submitted by webmaster on 16 May 2024

Vetonit Bond Pure

Multipurpose bonding agent & admixture.

Vetonit Bond Pure is a single component polyvinyl acetate-based, admixture & bonding agent for cementitious materials. It is water-based, with a thixotropic effect, specially formulated to enhance bonding properties and improve mechanical strengths of cementitious mixes when incorporated with mixing water. Vetonit Bond Pure also reduces shrinkage cracks during the early stages of cement hardening by minimizing surface water loss in freshly applied mixes. Vetonit Bond Pure can be diluted on site with potable water for desired applications.

Uses

  • Works as an admixture with plaster, lime/sand cement screeds, renders, mortars, and cement grouts.
  • Works as a bonding agent and can be sprayed or brushed on green substrates to improve bonding of plasters, patching compounds.
  • For renders, mortars, joint tape fixing, etc.
  • Use for both internal and external applications.

Advantages

  • Multipurpose usage.
  • It can be used as a bonding agent & admixture.
  • Enhances bonding of plaster, sand/cement screed, renders, etc.
  • Improves hydration & curing when added to cementbased mixes.
  • Improves compression strength & abrasion.
  • It adheres well to various construction materials, including concrete, stone, etc.
  • Ensure brighter & long-lasting color to architectural finishes.
  • Reduces shrinkage & cracks.

Usage Instructions

Clean the surface well and free it from loose materials. Eliminate inconsistent parts, varnishes, grease, laitance, algae through sandblasting or brushing before applying Vetonit Bond Pure.

Vetonit Bond Pure is a highly concentrated material. Make sure the correct dilution ratio is followed to avoid stiff & fast drying mixture. Follow the dilution ratio required for each type of premixed mortar.

Dilute 1 part Vetonit Bond Pure with 7 parts water. Mix thoroughly to obtain uniform consistency liquid.

Add the diluted Vetonit Bond Pure to pre-blended sand/ cement plaster, mortar, or other dry mixes. Mix for 3-4 min using a mechanical mixer at low speed. Allow the mixture to stand for 10 minutes, then mix again briefly to achieve a homogeneous, lump-free consistency.

Dilute 1 part Vetonit Bond Pure with 3 parts water. Mix thoroughly to obtain uniform consistency liquid.

Apply using a brush or spray directly onto the substrate. If using a hand pump, spray at a rate of 15 m2/liter. While the bonding agent is still wet, follow immediately by applying plaster, render, mortars or joint tapes, etc. 

Note: Vetonit Bond Pure should remain tacky when applying top coat finishes.

Clean tools with water before it hardens. Clean hardened residuals mechanically only.

DOWNLOADS

EXPLORE MORE PRODUCTS

Plastering Bond

Bonding agent and admixture for render and plaster.

Bonding Agents & Primers

Vetonit Bond 2

Multipurpose, low viscosity bonding agent & admixture.

Bonding Agents & Primers

Ready-Mix Bond

Multi-Purpose Bonding Agent & Admixture.

Bonding Agents & Primers