Bonding agent & admixture for render & plaster
Plastering Bond is a single component polymer based, bonding agent for cementitious materials. It is a water based, specially formulated to enhance bonding properties as well as improve mechanical strengths of plaster mixes when incorporated with mixing water. Plastering Bond also reduces shrinkage cracks during early stages of cement hardening by minimizing surface water loss in fresh applied mixes. Plastering Bond is ideal for use with Render and Plaster mixes. Plastering Bond is supplied as ready to use on site without any dilution for desired applications.
Vetonit Plastering Bond is supplied in 20 Liter Containers, Theoretical Coverage: 4 - 6 m²/Ltr as bonding agent
Original sealed container of Vetonit Plastering Bond has a shelf life of 12 months provided it is stored clear of ground in a dry shaded place below 25ºC.
Plastering Bond is non-flammable.
It is recommended to mix the material in same container prior to use.
Follow the Plastering Bond addition rates as specified by consultant or contractors required for each type of premixed mortar.
Plastering Bond can be used as total or partial replacement of gauging water required for plaster & render mixes.
Add the Plastering Bond to pre-blended sand/cement based plaster, render, mortar, or other dry mixes. Mix for 3-4 min using mechanical mixer at low speed.
Let the mixture stand for 10 min and mix again briefly to achieve homogeneous lump free mixture.
As a Primer
Use neat Plastering Bond without dilution. Apply Plastering Bond using brush or spray directly onto substrate. If using hand pump, spray at a rate of 4-6 m2/litre.
While bonding agent is wet to tacky, follow immediately by applying plaster, screed, render, mortars etc.
Note: Vetonit Plastering Bond should remain tacky when applying top coat finishes.
Surface must be well cleaned and free from loose materials. Inconsistent parts, varnishes, grease, laitance, algae, must be eliminated through sand blasting or brushing before applying Plastering Bond.
Use the whole material once you opened the pack, as the material start to skin & then dry. Any part material left in container must be kept air tight.
Do not mix with any additives or products unless recommended by saveto.
Tools should be cleaned with water before it hardens. After the hardening its residuals can be removed mechanically only.
For further information contact our technical department.
Vetonit Plastering Bond is irritant and harmful therefore avoid direct contact with eyes or skin. It is recommended to use protective gloves and goggles during application. In case of contact with eyes, clean immediately with plenty of clean cold water and seek medical advise.
Ensure adequate ventilation when using the material and avoid inhalation of vapours.
Refer to Material Safety Data Sheet for further information.
Saveto endeavors to ensure that any advice, recommendations, information it may give, is accurate and correct. It cannot accept any liability either directly or indirectly arising from the use of its products, because it has no direct or continuous control over where or how its products are applied, whether or not in accordance with any advice, specification, recommendation or information given by us. Saveto has the right to change any of the specifications mentioned in the Technical data sheets upon its discretion without prior notification.
Hard copies of TDSs are printed once or twice a year, while our technical data sheets are continuously being updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.
Multi-purpose bonding agent & admixture
Multipurpose low viscosity bonding agent & admixture
High Quality Monofilament Polypropylene Fibers
Polymeric soil stabilizer
Polymeric bonding agent, waterproof mix enhancer & primer
Premixed cementitious masonry grout