Vetoproof CM744

All surfaces should be dry and free from contamination, such as oil, grease, loose particles, decayed matter, moss algal growth, laitance, and all traces of mold release oils and curing compounds. This is best achieved by lightly gritblasting the surface. Where moss, algae, or similar growths have occurred, treatment with a proprietary biocide should be carried out after the grit-blasting process. 

Spalled and deeply disintegrated concrete should be removed to sound concrete and repaired with a Saveto repair system. It is essential that all surfaces that receive Vetoproof CM744 be pre-soaked with clean water before applying Vetoproof CM744. 

For further advice, consult the local Saveto office.

Pour Vetoproof CM744 liquid concentrate from the plastic container into a suitably sized mixing container. Commence mixing with a propeller agitator attached to a slow speed drill (300 - 500 rpm). Add the powder component gradually to the liquid to avoid lump formation and mix for 2 to 4 minutes. Use Vetoproof CM744 immediately after mixing. Do not mix more material than can be used within the pot life. Keep mixing Vetoproof CM744 during the application.

For best results, surfaces should be damp. To obtain the protective properties of Vetoproof CM744, observe the correct rates of the application. Use a short, stiff brush, preferably 120-200 mm width, and apply in one or two coats as required. Trowel applications should use the correct mixing ratio to obtain satisfactory consistency. 

The application of Vetoproof CM744 should not commence if the temperature of the substrate is below 5°C. Application of Vetoproof CM744 on hot substrates, i.e., over 35°C, is not recommended. It is recommended that for general resurfacing, each coat should be 1mm thick. Areas subjected to light foot traffic should receive at least 2 mm thickness of Vetoproof CM744, and an additional 2 mm should be applied if conditions are moderate to heavy pedestrian traffic. If in doubt about the condition of the substrate, consult Saveto technical department for any additional information.

Clean tools with water promptly before material hardens. Hardened material can be mechanically removed.

Allow the Vetoproof CM744 to cure for at least 28 days before commissioning.