Vetonit Base WR

The surface should be sound, clean, and free from loose material, grease, laitance, dirt-curing compounds, etc.

 Before the Vetonit Base WR application, wet the entire surface with clean potable water. The surface should look damp when you begin the application process.

Internal Block Walls & Rough Surfaces

For manual application, mix 7.5-8.5 litres of water and the entire contents of the 25 Kg bag of Vetonit Base WR.

For the Spray machine application, use 9.5-10.0 litres of water for each 25 kg bag. Add the powder to the water and mix with a mechanical mixer, or use a low-speed electric drill fitted with a suitable paddle. Mix until achieving a uniform, lump-free consistency. Allow the mixture to stand for about 10 minutes, then remix briefly without adding more water.

Smooth Concrete Surfaces

Add 0.5 litres of Vetonit Base WR to the mixing water and adjust the water requirement based on the above. 

Use the mixed material within 2 hours. Do not add water to the mix once the mixed mortar begins to harden.

Apply Vetonit Base WR to achieve a maximum total thickness of 5 mm, which is roughly 1-2 mm per layer. 

To obtain different finish textures, select the appropriate gun nozzle size or vary the spraying distance. 

Leave the material undisturbed for at least 48 hours.

Cure Vetonit Base WR by spraying the surface with water every 12 hours for a minimum of 3 days. In hot & dry conditions, allow curing for a minimum of 5 days. This will help achieve a uniform colour, minimise the risk of surface cracks, and lead to higher mechanical strengths.

Clean all tools with water immediately after finishing. Clean hardened materials mechanically.